[b]re:gugong: DHCP服务器的配置问题！！急！！！请帮忙！！[/b]

gaussong

etc/sysconfig/dhcpd
这个文件我的系统里面没有啊！！！
究竟要怎么做？！是啊，老版，我是DHCP目录是在
/var/state/dhcp
里面的这样有关系嘛？！
我是一个初学者，给点STEP BY STEP好吗？！

还有的是：我的ETH0网卡的IP地址是192.72.0.11；而DHCP要分配的IP地址是另一个网段的IP地址：51.132.235.0/24的网段。
这是位于路由器两端的网段；而且，我在使用WINDOS2000的时候是可以实现的，现在最大的问题是解决网卡和分配地址不在同一网段的问题！
请老版指教！！！
3x！

gugong

你的网络比较复杂，呵呵。肯定不是初学者，呵呵。

使用 dhcp relay


       The names of the network interfaces on which dhcpd should listen for broadcasts may
       be specified on the command line.  This should be done on systems  where  dhcpd  is
       unable  to  identify  non-broadcast interfaces, but should not be required on other
       systems.  If no interface names are specified on the command line dhcpd will  iden?
       tify all network interfaces which are up, elimininating non-broadcast interfaces if
       possible, and listen for DHCP broadcasts on each interface.

       If dhcpd should listen on a port other than the standard (port 67), the -p flag may
       used.   It  should be followed by the udp port number on which dhcpd should listen.
       This is mostly useful for debugging purposes.  If the -p  flag  is  specified,  the
       server will transmit responses to clients at a port number that is one greater than
       the one specified - i.e., if you specify -p 67, then the server will listen on port
       67  and  transmit to port 68.  Datagrams that must go through relay agents are sent
       to the port number specified with the -p flag - if you wish to use  alternate  port
       numbers,  you  must configure any relay agents you are using to use the same alter?
       nate port numbers.