ADSL问题请教

alfal · 发表于 2006-3-17 13:22:55

按说明配置好ADSL之后，能看到本地IP，能Ping通网关，也能Ping通其它IP，但是其它的啥服务都用不了，是怎么回事？有人遇到过么？
SSH到IP失败，FTP到IP失败，telnet 到IP的80端口失败，都是提示timeout

adsl-status 信息

[code:1]
[root@alfa alfa]# /sbin/adsl-status
adsl-status: Link is up and running on interface ppp0
ppp0    Link encap:Point-to-Point Protocol
      inet addr:221.223.97.18  P-t-P:221.223.96.1  Mask:255.255.255.255
      UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1492  Metric:1
      RX packets:17 errors:0 dropped:0 overruns:0 frame:0
      TX packets:14 errors:0 dropped:0 overruns:0 carrier:0
      collisions:0 txqueuelen:3
      RX bytes:1162 (1.1 KiB)  TX bytes:689 (689.0 b)
[/code:1]

ifconfig

[code:1]
[root@alfa network-scripts]# /sbin/ifconfig
eth0    Link encap:Ethernet  HWaddr 00:00:E8:AE:14:5B
      inet addr:192.168.0.2  Bcast:192.168.0.2  Mask:255.255.255.255
      inet6 addr: fe80::200:e8ff:feae:145b/64 Scope:Link
      UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
      RX packets:1815 errors:0 dropped:0 overruns:0 frame:236
      TX packets:849 errors:0 dropped:0 overruns:0 carrier:0
      collisions:0 txqueuelen:1000
      RX bytes:352137 (343.8 KiB)  TX bytes:51202 (50.0 KiB)
      Interrupt:217 Base address:0xe000

lo       Link encap:Local Loopback
      inet addr:127.0.0.1  Mask:255.0.0.0
      inet6 addr: ::1/128 Scope:Host
      UP LOOPBACK RUNNING  MTU:16436  Metric:1
      RX packets:1662 errors:0 dropped:0 overruns:0 frame:0
      TX packets:1662 errors:0 dropped:0 overruns:0 carrier:0
      collisions:0 txqueuelen:0
      RX bytes:1924588 (1.8 MiB)  TX bytes:1924588 (1.8 MiB)

ppp0    Link encap:Point-to-Point Protocol
      inet addr:221.223.96.192  P-t-P:221.223.96.1  Mask:255.255.255.255
      UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1492  Metric:1
      RX packets:918 errors:0 dropped:0 overruns:0 frame:0
      TX packets:417 errors:0 dropped:0 overruns:0 carrier:0
      collisions:0 txqueuelen:3
      RX bytes:108031 (105.4 KiB)  TX bytes:17234 (16.8 KiB)[/code:1]

网关信息

[code:1]
[root@alfa network-scripts]# netstat -nr
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
221.223.96.1 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0
192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth0
0.0.0.0 221.223.96.1 0.0.0.0 UG 0 0 0 ppp0
[/code:1]

DNS
[code:1]
[root@alfa alfa]# cat /etc/resolv.conf
# MADE-BY-RP-PPPOE
nameserver 202.106.46.151 [color=red]网关分配的[/color]
nameserver 202.106.0.20  [color=red]我一直用的DNS[/color]
[/code:1]

ping 网关
[code:1]
PING 221.223.96.1 (221.223.96.1) 56(84) bytes of data.
64 bytes from 221.223.96.1: icmp_seq=0 ttl=255 time=11.7 ms
wrong data byte #22 should be 0x16 but was 0x0
#16    10 11 12 13 14 15 0 87 36 99 0 87 36 99 0 87 36 99 0 87 36 99 16 17 18 19 16 17 18 19 16 17
#48    18 19 95 ea 0 0 95 ea
64 bytes from 221.223.96.1: icmp_seq=1 ttl=255 time=20.5 ms
wrong data byte #22 should be 0x16 but was 0x0
#16    10 11 12 13 14 15 0 0 e8 ae 0 0 e8 ae 0 0 e8 ae 16 17 18 15 16 17 18 19 16 17 18 19 16 17
#48    18 19 14 5b 0 e0 14 5b
64 bytes from 221.223.96.1: icmp_seq=2 ttl=255 time=20.0 ms
wrong data byte #22 should be 0x16 but was 0xb6
#16    10 11 12 13 14 15 b6 21 0 0 b6 21 0 0 b6 21 0 0 16 17 18 15 16 17 18 19 16 17 18 19 16 17
#48    18 19 0 0 70 2 0 0
64 bytes from 221.223.96.1: icmp_seq=3 ttl=255 time=19.8 ms
wrong data byte #22 should be 0x16 but was 0x0
#16    10 11 12 13 14 15 0 0 68 11 0 0 68 11 0 0 68 11 16 17 18 15 16 17 18 19 16 17 18 19 16 17
#48    18 19 42 18 58 49 42 18

--- 221.223.96.1 ping statistics ---
4 packets transmitted, 4 received, 0% packet loss, time 3003ms
rtt min/avg/max/mdev = 11.788/18.049/20.521/3.623 ms, pipe 2[/code:1]

Bluedata · 发表于 2006-3-17 13:35:58

能 ping 通你要 ssh 的 IP 不？

alfal · 发表于 2006-3-17 14:02:43

[quote:9bdf903391="Bluedata"]能 ping 通你要 ssh 的 IP 不？[/quote]

可以Ping通，机器肯定是开着的，

OS:CentOS 4.2 x86_64
rp-ppoe:3.5.22

gucuiwen · 发表于 2006-3-17 16:00:02

确定对方开着SSH服务吗? 确定对方的防火墙允许SSH连接吗?

确定自己的防火墙允许对外连接SSH端口吗?

iptables -L

看看.

alfal · 发表于 2006-3-17 16:22:45

[quote:7b12a98888="gucuiwen"]确定对方开着SSH服务吗? 确定对方的防火墙允许SSH连接吗?

确定自己的防火墙允许对外连接SSH端口吗?

iptables -L

看看.[/quote]

SSH肯定是开着的，在WINXP下面能正常登陆

iptables -L

[code:1]
[root@alfa alfa]# /sbin/iptables -nL
Chain INPUT (policy ACCEPT)
target    prot opt source             destination

Chain FORWARD (policy ACCEPT)
target    prot opt source             destination

Chain OUTPUT (policy ACCEPT)
target    prot opt source             destination
[/code:1]

Bluedata · 发表于 2006-3-17 16:46:16

修改一下 ppp0 设备的 MTU 值，改为 1452 试试呢。

alfal · 发表于 2006-3-17 16:56:31

[quote:49bd7ac837="Bluedata"]修改一下 ppp0 设备的 MTU 值，改为 1452 试试呢。[/quote]

在哪儿改？能说的更详细一点儿么？

Bluedata · 发表于 2006-3-17 17:09:47

ifconfig ppp0 mtu 1452

		自动登录	找回密码
密码			注册